How do you get Euclid diamond hard?
Apply with high-volume, low-pressure sprayer, then scrub EUCO Diamond Hard into the surface with fine-bristled brooms or an auto scrubber. After keeping the entire surface wet with EUCO Diamond Hard for 30-40 minutes, the material thickens slightly and becomes gel-like.
What is euco diamond hard?
EUCO DIAMOND HARD is a unique blend of silicate and siliconate polymers that penetrate concrete surfaces and chemically react to provide an increase in surface density, durability, and abrasion resistance. Concrete treated with EUCO DIAMOND HARD is dust-proofed, resists tire marks, and is easier to maintain.
How do you use diamond clear sealer on concrete?
Apply sealer uniformly to the concrete using sprayer, then lightly backroll the sealer to ensure even coverage. Maintain a “wet edge” while spraying, and backroll over sprayer lap marks for best appearance.
How do you apply Liqui hard?
No further application steps are required for fresh concrete. Existing (Old) Concrete: Saturate the surface with undiluted LIQUI-HARD by sprayer, squeegee or broom. Keep the surface wet with LIQUI-HARD for a minimum of 30 minutes. (A range of 30 – 60 minutes may be required depending on temperature and conditions.)
How do you use euco clean and strip?
Apply the Euco Clean & Strip solution to the floor while scrubbing with a stiff broom or mechanical floor scrubber. Then, allow the Euco Clean & Strip solution to dwell on the surface for sufficient time to soften the soil, curing compounds, or cure & seal. This typically takes 20 to 40 minutes.
How long does Diamond seal last?
– The Diamond Clear did fairly well with fading after 2 years and was on par with other solvent-based sealers containing similar amounts of acrylic.
How long does diamond clear last?
3 years in original, unopened package. Sealing 450 to 550 400 to 450 Older Concrete (11.0 to 13.5) (9.8 to 11.0) Coverage will vary depending on surface porosity and texture.
What does concrete hardener do?
Concrete wears out over time. The lifespan depends on the use and maintenance of your concrete floor. Concrete hardeners and densifiers are used to prevent floors from wearing out prematurely. These products protect, preserve, and strengthen concrete flooring through a uniform curing and sealing process.
What causes dusting in concrete?
Dusting is the release of powders when the concrete moves or is being touched. The dust occurs when the surface of the concrete is not strong enough and is friable and porous. A porous surface is weak and fragile and in turn can lead to more dusting.
Does xylene remove concrete sealer?
Xylene will work good for removing solvent based concrete sealers. It’s a little messy, but Xylene will re-emulsify the concrete sealer and soften it to the point where you an pressure wash it off. You can pour or spray on the Xylene in a small section, don’t let the xylene evaporate.
How long does it take diamond clear concrete sealer to dry?
Penetrating sealers usually fully dry for traffic in less than 24 hours with topical sealers generally taking up to 48 hours to fully dry for traffic. Actual drying time is based on temperature, humidity, and air flow.
Can you spray Super Diamond Clear?
Maintain a “wet edge” while spraying, and backroll over sprayer lap marks for best appearance. SUPER DIAMOND CLEAR may be applied by roller alone, but extra care must be taken to ensure that the sealer is applied uniformly, and at the proper coverage rate.