How do you read the airbag light code?
To read the codes, count the number of times the light flashes, wait for the pause and count the flashes again. For example, two flashes, a pause and four flashes mean that your airbag system’s problem is a code 24. Code 12 means your battery voltage is low, while 13 means the airbag circuit is shorted or grounded.
What does airbag light mean on Hyundai?
It uses the sensors in your Hyundai to determine what action is necessary when your vehicle has been in an accident or collision. There are a few reasons why the airbag light may come on. It may indicate that there is a problem with your seat belts. Another issue could be water damage to the sensors.
What are SRS codes?
The SRS warning light indicates a malfunction in the airbag system, front passenger occupant classification system or the seatbelt pretensioner system.
How do you reset the airbag light on a Hyundai?
Turn on the code reader and move the arrows on the menu to the “Erase” function and then press “Enter”. Remove the OBD II code reader from the DLC and start the engine. Look at the instrument panel to make sure the airbag light turned off.
Can I drive with the airbag light on?
The bottom line is that, when your airbag light comes on, it’s vital that you don’t drive any further and have your car checked by a mechanic as soon as possible. Until the problem is diagnosed and fixed, your airbags will not deploy.
Where is the airbag sensor?
The sensor is positioned inside the engine and a similar safety sensor is located inside the passenger zone of the vehicle. This safety sensor is required to measure the intensity of the collision to determine whether the impact is over a certain threshold to justify the release of an airbag.
How to reset the airbag light on a Hyundai?
Locate the OBD-II port under the dashboard.
How to turn off an airbag light?
How to Turn Off the Airbag Light. Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total. Turn your ignition switch back on to fully reset the airbag light.
Why does your airbag light blink off and on?
● Broken or damaged parts: The Airbag light may illuminate due to one or more damaged components. It can happen due to a variety of reasons including old or worn-out components mainly due to poor maintenance and water seeping into the vehicle.
Why does my airbag warning light keep coming on?
Airbag Deactivated. The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off.