How do you reset the throttle body sensor on a Honda Civic?
Follow these steps:
- Connect your scanner to the OBD2 port under your dash.
- Use the buttons on the scanner to navigate to the TP POSITION CHECK menu.
- Reset the TP value.
- Select RELEARN PROCESS after the TP value has been reset.
How do I reset my Honda TPS?
How to Reset Tire Pressure Monitoring System in Newer Honda Vehicles
- From the home screen, select Settings.
- Select Vehicle.
- Select TPMS Calibration.
- Select Calibrate.
Will a throttle position sensor keep a vehicle from starting?
No Start Condition Quite rarely but surely enough a bad throttle position sensor can create a no-start condition where you may be able to just crank the engine and not turn it over.
What is TPS Honda Civic?
Honda Civic Throttle Position Sensor (TPS)
How to replace and calibrate throttle position sensor Honda Civic?
Honda Civic: How to Replace and Calibrate TPS. 1 Step 1 – Remove the TPS. To remove the old TPS, first disconnect the throttle position sensor wiring harness. Remove the two 12mm bolts and nuts to 2 Step 2 – Install new TPS. 3 Step 3 – Calibrate the new TPS. 4 Featured Video: How to Calibrate TPS Sensor.
How do you remove a throttle position sensor?
To remove the old TPS, first disconnect the throttle position sensor wiring harness. Remove the two 12mm bolts and nuts to access the TPS. There are either two Torx screws or two machine screws holding the TPS in place, depending on which model you have.
What is a throttle position sensor (TPS)?
The throttle position sensor, or TPS, is used to control the actual throttle position relative to the amount of feedback it receives from the “Go Pedal.” If this sensor falls out of calibration or fails, you may experience issues controlling the throttle of the car. This article applies to the Honda Civic/Del Sol (1992-2000).
How do you replace a TPS on a 1996 Honda Civic?
Figure 1. The TPS unit on a 1996 Honda Civic. Install a new gasket on the new TPS. Place the new TPS in the same groove as the old one, and then install two new fasteners using a 4mm Allen wrench. Be careful not to overtighten as the plastic will break easily.