How do you identify a 312 Y-block?
- 312 crankshafts typically have an identifying mark on the crankshaft flange. This cannot be seen if the engine is installed in the vehicle with an automatic transmission.
- 312 main caps are always marked ECZ , all other Y-Block main cap are marked EBU. This is the only positive way to identify a 312 block.
Is a 292 Y-block a V8?
In 1956 Ford replaced the P-code 292 with a new 312 in³ “Thunderbird Special V8” version of the Y-Block, while the M-code 272 was replaced with a new M-Code specification of the 292. This M-code “Thunderbird V8” 292 was now optional on all Fords.
Was the Ford Y block a good engine?
Otherwise, the Y-Block proved to be a rugged and reliable engine, and while it was replaced by the Windsor V8 for passenger car use in 1962, it continued as a mainstay in the Ford truck line for several more years.
What year did the Ford 312 come out?
The 312 was rolled out in 1956 and it was used in higher end models of the Ford and Mercury line. Most people know it best from being installed in the Thunderbirds of the era.
When did Ford introduce the 312 engine?
How much does a Ford 312 engine weigh?
| ENGINE | Weight | Comments |
|---|---|---|
| pounds | ||
| Ford Y block V8 | 625 | (272-312 CID) |
| Ford FE big block | 650 | (332-428 CID) |
| Ford FE big block | 670 | (’59 352 CID) |
What did the 460 come in?
Ford’s most popular, longest-lasting big block V8 engine lived an incredibly varied life. The 460 cubic inch eight-cylinder motor debuted all the way back in 1968 but found itself powering cars, trucks, and commercial equipment all the way to the end of the 1990s during its three decade run.
What years did Ford make the 312 engine?
When were 312 CI engines installed in Y block Ford trucks?
The following information compiled from FoMoCo data supports the fact that 312 CI engines were not installed during production of Y block Ford trucks from 1954 until the end of production in 1964 at any of the assembly plants.
What is the cubic inch of a Ford Y block engine?
The Y block engines used in Ford Trucks from 1954 – 1957 had the following cubic inch displacement, 239 CI, 256 CI and 272 CI. The 292 engine, although available in 1955 for passenger cars, was not used in Trucks until 1958.
What is the RPM range of a 272 Y block camshaft?
272, 292, 312 Y-Block Ford Manual Transmission or Higher Stall is recommended or lower rear end gears * Ford-o-Matic Not recommendedStreet / Strip Healthy Idol and Exhaust RPM Range 2500-6200 272, 292, 312 Y-Block… 272, 292, 312 Y-Block Ford This Camshaft will provide outstanding low and mid range performance.
How do I contact Y block parts?
E-MAIL: [email protected] We don’t check e-mail everyday so best to call! Yamaha YFZ-450 Honda TRX-450 specialists. V-10,V8, V6, 4 cyl, Singles.