What is the default password for Cisco Aironet AP?
After the access point rejoins a controller, it adopts the default Cisco/Cisco username and password.
How do I start configuring network?
To manually set your network settings:
- Open the Activities overview and start typing Settings.
- Click on Settings.
- If you plug in to the network with a cable, click Network.
- Click the.
- Select the IPv4 or IPv6 tab and change the Method to Manual.
- Type in the IP Address and Gateway, as well as the appropriate Netmask.
What is the Cisco Aironet 1600 series access point?
This Guide provides instructions on how to install and configure your Cisco Aironet 1600 Series Access Point. The 1600 Series Access Point is referred to as the 1600 series or the access point in this document. The 1600 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated and external antenna options.
What are the radio configurations of the 1600 series access point?
The radio configurations of the 1600 series access point are: AIR-CAP1602E-x-K9, AIR-SAP1602E-x-K9—controller-based mode, with two 2.4-GHz/5-GHz dual-band radios with up to 3 external dual-band dipole antennas
Do I need a license to use a Cisco Aironet access point?
Cisco Aironet Access Points are certified to the requirements of RSS-210. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.
Can I use a 1600 series access point with WDS devices?
Keep these guidelines in mind when you use 1600 series lightweight access points: The access point can only communicate with Cisco wireless LAN controllers, such as 2500 series, 5500 series, and WiSM controllers. The access point does not support Wireless Domain Services (WDS) and cannot communicate with WDS devices.