How do I know if my tanning bed bulbs are bad?
While they may continue to light up for that long, they will not retain the effectiveness they had at, say, 50 hours of use. Over time, it will take longer and longer to get the same tan. By 500 to 800 hours of use, most tanning bulbs have lost enough potency that they should be replaced.
How do you test a tanning bed starter?
Take out a lamp that won’t light and switch it with a lamp that was lighting. If the lamp now lights, it’s time to replace the starters. Session times with higher-wattage lamps are almost always shorter.
Why is my tanning bed not getting hot?
The most common reasons that tanning lamps do not perform as expected are temperature, acrylic condition and cooling system related.
Do tanning bed bulbs go bad if not used?
How do I know if my tanning bed ballast is bad?
If you are finding the lamps of the tanning bed aren’t lighting to full capacity, it may be a sign of a bad bulb or ballast. If it is the bulbs, there will usually be a total loss of illumination with most bulbs, but can also show itself as a flickering since florescent can also operate at diminished powers.
Will a bad ballast burn out bulbs?
Causes of Ballast Failure When it’s too hot or too cold, the ballast can burn or fail to start your lamps at all.
What lamps are used in the 24s and 28le model series?
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE 24S AND 28LE MODEL SERIES: GOLDEN TAN™ Wolff® Model GT71-T12-100W BI-PIN or Velocity® Wolff® Model VEL 71-T12-100W(Full length lamps) GOLDEN TAN™ Wolff® Model GT59-T12-80W BI-PIN or Velocity® Wolff® Model VEL 59-T12-080W(Short lamps in 24SF)
Why do you ask me to select the number of bulbs?
So, by simply asking you to select the number of bulbs in your unit, we can in most instances identify, and match with a Wolff product of equal or better performance. Beyond that we give you options based on your style of tanning, but always keeping you centered on your bed and original bulb type you’ve selected.
Can I connect my sunbed to a higher voltage?
The sunbed’s remote interface circuitry oper- ates on 5 volts, attempting to connect it to any higher voltages will damage the sunbed as well as void your warranty. CAUTION 12 Installation – Remote Connections 25108-01A T-Max® 1A and 3A Remote Systems