What is the range of an 82 mm mortar?
82 mm HE mortar projectiles generally contain anywhere between 392 g and 680 g of HE and have maximum ranges of between 3,000 – 5,500 m.
How much does a 60mm mortar system cost?
$10,658
The M224 60 mm Lightweight Company Mortar System (LWCMS) is a smooth bore, muzzle-loading, high-angle-of-fire mortar used for close-in support of ground troops….
| M224 mortar | |
|---|---|
| Unit cost | $10,658 |
| Variants | M224 M224A1 |
| Specifications | |
| Mass | 21.1 kilograms (47 lb) |
What is the range of a 4.2 inch mortar?
| M2 4.2-inch mortar | |
|---|---|
| Rate of fire | 5 rpm for 20 minutes 1 rpm indefinitely |
| Muzzle velocity | 250–256 m/s (820–840 ft/s) |
| Effective firing range | 515 m (563.21 yd) |
| Maximum firing range | 4.4 km (2.7 mi) |
How much does a 4.2 mortar round weigh?
It was nicknamed the “Goon Gun” (from its large bullet-shaped shells, monopod, and rifled bore – like a rifle for shooting Goons) or the “Four-Deuce” (from its bore size in inches)….
| M2 4.2-inch mortar | |
|---|---|
| Shell | 11–13 kg (24 lb 4 oz – 28 lb 11 oz) |
| Caliber | 107 mm (4.2 in) |
| Rate of fire | 5 rpm for 20 minutes 1 rpm indefinitely |
What is an M29 mortar?
The M29 is an American-produced 81 millimeter mortar. It began replacing the M1 mortar in U.S. service in 1952 being lighter and with greater range. It was subsequently replaced by the M252 mortar in 1987.
How many rounds does a M29A1 shoot?
Variants included the M29E1 and M29A1, adopted in 1964. These were produced with a hard chrome-plated bore to prolong barrel life and ease of cleaning. The maximum rate of fire is 30 rounds for the first minute followed by 4 to 12 rounds per additional minute.
What are the different types of mortar cement?
Available in Types M, S, and N, each meets ASTM C 270, ASTM C 1714 and CSA A179 requirements. SPEC MIX Mortar Cement & Sand is available in color and is formulated for the installation of CMU and brick units where high mortar workability and board life is required for good bond.
What should be the specifier for mortar?
The specifier should evaluate the interaction of the mortar type and masonry unit specified. That is, masonry units having a high initial rate of absorption will have greater compatibility with mortar that has a high water retentivity.