Why is my castle ESC beeping?
If the ESC’s voltage cutoff is set to Auto-LiPo (the default setting), then the ESC will emit a sequence of beeps indicating the number of battery cells – If the number of beeps does NOT match the number of cells, disconnect the battery and confirm that it is fully charged.
How do you reprogram ESC?
Move the throttle stick to Full Throttle, then connect the battery pack to the ESC. The motor will give 2 beeps after 2 seconds. 3. Wait another 5 seconds and the ESC will give a rising tone to indicate you have entered Programming Mode.
Why is my ESC flashing red and green?
If the Low-Voltage Detection (LVD) is “ON” when a nickel-metal hydride (NiMH) battery is used an ESC may show the over-voltage alarm, indicated by a flashing red and green light.
How do I manually calibrate my ESC?
Manual ESC-by-ESC Calibration
- Plug one of your ESC three-wire cables into the throttle channel of the RC receiver.
- Turn on the transmitter and set throttle stick to maximum (full up).
- Connect the LiPo battery.
- You will hear a musical tone then two beeps.
- After the two beeps, lower the throttle stick to full down.
How do I program an ESC?
Exit Program Mode Move the throttle stick to Full Throttle, then connect the battery pack to the ESC. The motor will give 2 beeps after 2 seconds. 3. Wait another 5 seconds and the ESC will give a rising tone to indicate you have entered Programming Mode.
What is neutral range on ESC?
Neutral range. This is the ‘dead zone’ before the ESC registers a command. Another way the think of this is how far you have to squeeze the trigger before the car starts moving. I like to tune this to the transmitter for control. Most 2.4ghz transmitters are very accurate so you can turn this down to 6% if you wish.
How do I reset my ESC?
1) Connect ESC 3-wire cable to program card; 2) Connect battery power; 3) With ESC powered OFF, press and hold the Reset button on the card while turning the ESC power on; 4) All the LEDs on the card light up for a second, then all settings should be returned to defaults.
Why is my ESC blinking red?
Your Traxxas ESC blinking red may indicate thermal shutdown protection has kicked in to prevent overheating. Another possibility is that LiPo battery voltage is nearing its minimum discharge level. On some ESCs, flashing red light means there’s been a current spike.
How do I program the Mamba Monster X 8s to my Device?
Program with a mobile device using a Castle B•Link Bluetooth® Adapter (sold separately) or using a Castle Field Link Portable Programmer (sold separately). The Mamba Monster X 8s features data logging. You will be able to measure and record important power system information during your race, turn-by-turn.
What is a mamba monster?
Castle Creations’ introduction of the Mamba Monster was a break-through moment for R/C modelers wanting to experience what seemed to be unobtainable. Brute power and sheer stamina have made this our legacy “power up” for popular 1/8th scale buggies, truggies and on road vehicles and 1/10th scale monster trucks.
What makes the Mamba Monster 2 ESC so special?
The Mamba Monster 2 ESC is capable of 2S LiPo to a maximum of 6S LiPo and is waterproof, which means you can run your vehicle through the morning dew, across the soggy snow or just about anywhere else you’d be interested in running a 1/8th scale RC buggy or truck. The Mamba Monster 2 includes a coupon for a free Castle Link USB device.