How do you read a Webasto code?
Webasto Heater Fault Codes – A Guide
- How Webasto Heaters Indicate A Fault.
- Air Top Heater Fault Codes.
- Webasto Digital Timer.
- Fault 00 (F00) – Control Unit Malfunction.
- Fault 01 (F01) – No Start.
- Fault 02 (F02) – Flame Failure.
- Fault 03 (F03) – Voltage.
- Fault 04 (F04) – Premature Flame Detection.
How do I reset my Webasto error code?
Error Lockout Reset Thermo Top C with “Timer” After correction of the malfunction the error lockout is reset by switching the heater off and on again. In case of overheating an error lockout reset is achieved by removing fuse F1, 20A for at least 10 seconds. The fuse is not blown in case of an overheat condition.
How do I change the time on my Webasto?
Press and hold the button. Press the “Forward” or “Reverse” button as well. The time of the day is displayed and the clock symbol flashes. Set the time via the “Forward” or “Reverse” buttons.
What is the power of Webasto air top 2000 St?
Autonomous air heaters Webasto Air Top 2000 ST operate on diesel fuel of the car and are used for heating cabins for sleeping trucks, minibuses, special equipment cabins, trailers and boats. The device with a power of 2 kW is ideally proven in a temperate climate.
What is the fault code on a Webasto heater?
Webasto Heater Fault Codes 00 -19 Fault 00 (F00) – Control Unit Malfunction This fault will appear if the heater thinks the electronic control unit (ECU) is faulty. The flash code will consist of the 5 quick flashes, a pause and then the 5 quick flashes again.
How do you fix a blown out sensor on a Webasto?
It can be corrected by simply clipping the overheat sensor back on the heat exchanger correctly. On other Webasto models it refers to a defective overheat sensor/blow out sensor. The usage wiring checks for cable damage and correct insertion of the plug should be checked before replacing the sensor.