How do I reset my Epson WF 3540 printer?
Press the home button, if necessary. Press the left or right arrow button and select Setup. Scroll down and select Restore Default Settings. Select Wi-Fi/Network Settings, then select Yes.
Why is my Epson printer not recognizing my ink?
Make sure that the cartridges are in the correct slots. Check the position using the coloured label guide, located on the plastic above the ink cartridge holder. Check that the plastic film on the bottom of the cartridge has been pierced. If it isn’t pierced, reinstall the ink cartridge into the printer.
Why does my Epson printer not Recognise ink?
How do I reset an ink cartridge?
Line up the ink cartridge with the marks displayed at the base of the chip reset tool. Each chip reset tool is uniquely shaped to accommodate ink cartridges from different Epson printer models.
How do I Reset my Epson cartridge chip?
You can use a paper clip to reset your Epson cartridge chip if there’s a single pinhole on the small green microchip on the bottom or side of the cartridge. If there are two round metal contacts at the top or bottom of the chip, you’ll actually need two paperclips. If you have a cluster of 7 to 9 pinholes instead, see this method.
Why does my ink cartridge say empty after I refill it?
This article has been viewed 164,827 times. If your Epson printer is reporting that your ink cartridge is empty after you’ve refilled it, you’ll need to reset its chip. Even if you didn’t refill the cartridge, there’s usually a bit of ink left in the “empty” cartridge that you can only use if you reset the chip.
What should I do if my ink cartridge is installed incorrectly?
Caution:If you see a message that an ink cartridge is installed incorrectly, lift up the scanner unit, open the cartridge cover, and press the ink cartridge down until it clicks into place. Then close the cartridge cover and lower the scanner unit.