How do I delete start time on Rainbird?
Press the right or the left arrows to toggle between start times and find one of the other start times to turn off. Press the + or – buttons to change the time setting. To turn the start time to “OFF” you will find it between “11:45pm and 12:00am”. Leave the time on off.
Why do my sprinklers continue to cycle over and over?
The Reason why a Controller Repeats a Cycle Over and Over The answer is usually there are too many programmed start times — program start times are being confused with zone (station) run times. Some controllers have up to eight start times per day to a single program (e.g. A).
How do I reset my rain dial RD 600?
Open the battery compartment and disconnect the battery. Press and hold the Manual button in and KEEP HOLDING IT IN while performing the next step. Reconnect the ribbon cable, then release the Manual button. Note: The display should now show 12:00 AM indicating the controller has reset.
Why is my Rainbird running twice?
How does Rainbird rain delay work?
Rain delay allows you to turn off the irrigation system for a specific number of days without having to remember to turn it back on. For example, if the weather forecast calls for three days of rain, you could stop irrigating for four or five days. This gives the soil time to dry out after the rainfall.
What does delay mean on Rainbird sprinklers?
This timer has the ability to delay the start of the next watering cycle for 24, 48, or 72 hours. Before running a rain delay cycle, the top dial must be set to the RESET position. After the confirmation flash of the light, the dial can be set to the desired delay length.
How do I reset my rain dial timer?
What time should I water my lawn?
You must avoid having wet grass at night as this promotes disease. Therefore, water before the heat of the day so that the lawn has time to dry before nightfall. You can put the sprinkler on anytime from 4am to early afternoon on most days even sunny ones.