How do I reset my HP LaserJet P3005?

Posted on by David Darling

How do I reset my HP LaserJet P3005?

HP LaserJet P3005 Printer Series – Blank Display

  1. Turn the device off.
  2. Turn the device on. When the memory count begins, press and hold the check button.
  3. After the message SELECT LANGUAGE appears on the display, press the arrow up or arrow down buttons until COLD RESET is highlighted.
  4. Press the check button.

How do I change the ink in my HP LaserJet P3005?

Print cartridge removal

  1. Open the cartridge door.
  2. Remove the used print cartridge from the device.
  3. Remove the new print cartridge from the bag.
  4. Grasp both sides of the print cartridge and distribute the toner by gently rocking the print cartridge.
  5. Remove the shipping tape from the new print cartridge.

How do I clean my HP LaserJet p3005 printer?

The printer must be in a ready state in order to start the cleaning process.

  1. Press Menu .
  2. Press (DOWN) to highlight CONFIGURE DEVICE , and then press (SELECT).
  3. Press (DOWN) to highlight PRINT QUALITY , and then press (SELECT).
  4. Press (DOWN) to highlight CREATE CLEANING PAGE , and then press (SELECT).

How do I change the IP address on my HP Laserjet p3005?

Set an IPv4 address

  1. Press Menu.
  2. Press (DOWN) to highlight CONFIGURE DEVICE, and then press (SELECT).
  3. Press (DOWN) to highlight I/O, and then press (SELECT).
  4. Press (DOWN) to highlight EMBEDDED JETDIRECT, and then press (SELECT).
  5. Press (DOWN) to highlight TCP/IP, and then press (SELECT).

How do I print on both sides HP?

Open the file to be printed, then open the printer Properties dialog box. Click the Printing Shortcuts tab, and then click Two-sided, duplex, printing (see Figure below). In the Print on both sides drop-down list, click Automatically (see Figure above). Select any other print settings wanted, and then click OK.

How do I reset my HP Laserjet p2015 printer?

Press and hold the GO button on the control panel of the printer. Turn on the printer and continue to hold the GO button for at least 50 seconds. During this process the Attention, Ready and Go lights turns on together. Then the Attention and Ready lights turns off, leaving just the GO light illuminated.

How do I do a clean cycle on my HP printer?

Click Settings ( ), and then click Printer Toolbox. The printer Toolbox opens. Click the Device Services tab, and then click Clean Printheads. Click Clean to begin the cleaning process, and then follow the on-screen instructions to complete the process.

Can laser toner be refilled?

Toner cartridges aren’t manufactured with refilling in mind. They are made for a single use, and although some refilling and remanufacturing is successful, often the desired results are unattainable.

How do I turn on double sided printing?

Set up a printer to print to both sides of a sheet of paper

  1. Click the File tab.
  2. Click Print.
  3. Under Settings, click Print One Sided, and then click Manually Print on Both Sides. When you print, Word will prompt you to turn over the stack to feed the pages into the printer again.

What do the lights mean on HP LaserJet P2015?

1. Jam light: Indicates that there is a jam in the printer. 2. Toner light: When the print cartridge is low, the Toner light illuminates. When the print cartridge is out of the printer, the Toner light blinks.