How long do BMW serpentine belts last?

Posted on by David Darling

How long do BMW serpentine belts last?

between 50,000 and 100,000 miles
How Long Do Serpentine Belts Last? Most modern serpentine belts are able to last anywhere between 50,000 and 100,000 miles, which is a fairly big window of time.

How long do drive belts last?

60,000 to 100,000 miles
Today, most serpentine belts are expected to last anywhere from 60,000 to 100,000 miles. Some belts can last significantly longer than this, while others give out before 60,000 miles. Make sure to check your owner’s manual to find out the recommended belt replacement time frame.

Can u drive with a broken serpentine belt?

Basically, you should be able to drive it to a safe space where it can be towed or repaired. If the belt is snapped and dangling in the engine compartment, remove it before moving the vehicle to prevent further damage.

How do you know if your serpentine belt is going bad?

If you suspect your serpentine belt is failing, watch out for the following symptoms:

  • Squealing noise from the front of the vehicle. If you notice a squealing noise coming from the front of your vehicle, it could be from the serpentine belt.
  • Power steering and AC not working.
  • Engine overheating.
  • Cracks and wear on the belt.

How do I know if I need a new serpentine belt?

The easiest way to know that a new serpentine belt is needed is if you hear it squealing while the engine is running. A heavy rainstorm might cause a bit of squealing, but if there are any fluid leaks, it’s time to replace it right away.

What is the correct oil grade for BMW E46?

We recommend an SL oil for pretty much all cars built before the E90 generation: E85, E83, E63, E60, E53, E46, E39, E38, Z3, E36, E34, and E32. It can be used in E30 and older models too but only in thicker viscosity. These cars can use an SN oil but SL is much more appropriate.

How to bleed cooling system on BMW E46?

Jack up the front end/put it on ramps.

  • Open up the bleed screw and fill the coolant to the fill line.
  • Set the heat at max temperature,and fan speed.
  • Start the engine and allow it to run up to operating temperature.
  • Put the fill cap back on and tighten it back down.

    • How to replace the wheel bearings on a BMW E46?

    Floor jack

  • Jack stands
  • Socket set and ratchet
  • Impact wrench
  • 6-mm hex wrench
  • Anti-seize compound
  • New hub and wheel bearing assembly

    • How do you set the time on BMW E46?

    yusteven. Just bought a used 2000 323i 4dr (built in 7/99).

  • bender
  • B. Click to expand…
  • mmtr 328i. You need to have the Key in position 1 or 2.
  • kmontesinos. I can not make this work on my 2000 325i.
  • ///Mostarac
  • dmax. I can not make this work on my 2000 325i.
  • Stickbuilder. If yours has the 99 model radio,it may not have the clock function.
  • scottjoh.
  • sherif65