Can I use any trim kit for my microwave?
A trim kit consists of the trim frame as well as an upper, lower and rear duct that attaches to and encases the microwave inside the cabinet cut-out. It is important to only use the trim kit designed for the specific microwave model so that the trim kit fits the microwave and provides the proper air flow that it needs.
How do I know what size microwave trim kit I need?
Determining which Trim Kit you need:
- Microwave models that have the built-in trim kit option will offer a 27″ and 30″ wide trim kit.
- The 27″ or 30″ width is the outside dimension of the trim frame.
- The only difference between the 27″ and 30″ trim kit is the trim frame.
Do you need a trim kit for over the range microwave?
For the easiest possible installation, you should buy an over the range microwave with a trim kit. Remember, standard models are not designed to be mounted.
What size microwave fits in a 30 inch trim kit?
You can go with a 30 inch, which will go edge to edge on the cabinet. Both trim kits work with a cutout of 25-1/2″ ± 1/8″ wide and 16-3/4″ ± 1/8″ tall. I hope this helps. thank you for checking with us.
What size microwave fits in a 27 inch trim kit?
The 27″ Trim Kit for 2.2 cu. ft. Countertop Microwave Oven (206635354) interior measurements are 12-1/4 inches high, and 22-3/4 inches wide.
Can you make an over-the-range microwave a built-in?
You can install an over-the-range microwave above a wall oven. However, it depends on the manufacturer. Before you jump into the installation, consult the manufacturer’s instructions. Over-the-range microwaves are not the same as built-in microwaves, so it’s important to double check the owner’s manual.
How tall is a microwave trim kit?
These are all of our “standard” microwave trim kits for all of the major brands that are available in 24”, 27” and 30” sizes.
Is microwave over stove outdated?
Over-the-range microwave While over-the-range microwaves have been stylish for years, the trend is on the way out in 2018.
Are built-in microwaves a standard size?
Built-in microwave Dimensions Capacity can range from 1.0 to 2.2 cubic feet, with most landing between 1.2 to 1.6 cubic feet. Widths align with standard cabinet widths, usually 24, 27 or 30 inches. Height typically ranges from 17 to 22 inches.
How much space do you need around a built-in microwave?
1″ clearance in the rear. The front edge of the microwave (measured at door) should sit at least 3″ or more back on the counter or shelf to avoid accidental tipping. If located on the counter near a range, we recommend locating it at least 2 ft away.
How do you remove a Panasonic microwave trim kit?
Insert a screwdriver behind the trim kit at the bottom. Pry it out slightly. Insert the screwdriver at the top and pry it out slightly. When the kit becomes loose, pull it off the cabinet with both hands.
Can you use an OTR microwave as a built-in?
How high does microwave need to be above stove?
The National Kitchen and Bath Association recommends that the bottom of the microwave should be no higher than 54 inches above the floor, which would allow for 18 inches of clearance between the microwave and the typical cooktop height of 36 inches. Some manufacturers allow smaller clearances.
Is it OK to put a microwave in a cupboard?
You can put a countertop microwave in a cabinet instead of a built-in type, as long as you follow the necessary safety precautions (ensuring adequate ventilation, the shelf is strong enough to hold it, and proper wire management) to ensure your cabinet and microwave don’t get damaged.