How do I adjust my Stihl Oiler?
Turn the chainsaw off to adjust the oiler. Insert a small flat-head screwdriver into the oil adjustment screw on the underside of the chainsaw. Turn the screw clockwise to increase oil flow or counterclockwise to decrease the oil flow, reveals Stihl USA.
Can you adjust the bar chain oiler?
With a narrow flat-tipped screwdriver, adjust the oil flow. To increase the oil flow, turn the automatic oiler adjustment screw counterclockwise.
Where is the oil relief valve on a Stihl chainsaw?
Look for the oil relief valve in the side of the engine housing, between the oil outlet port and the guide bar studs. Push against the valve with the 16-gauge wire. A little oil should seep from the valve unless the valve is blocked or stuck. Pushing the valve once should free it, allowing oil to seep.
How do you adjust the Oiler on a Stihl MS 311?
Locate the oil adjuster screw on the bottom of the chainsaw. Turning this screw will adjust the oil feed rate. Turn the screw clockwise to increase the oil feed. Turn the screw counterclockwise to decrease the oil feed.
Why is my chainsaw leaking bar oil?
What causes a chainsaw to leak oil? As the oil is pumped from the tank through to the guide bar, air begins to replace the space where the oil was previously stored. If there isn’t proper ventilation of the oil tank, a vacuum can occur and reduce the flow of oil to the guide bar.
How do you adjust the Oiler on a Stihl MS 310?
Why does my Stihl chainsaw leak oil when not in use?
This condition is deemed to be normal for any chainsaw with a similar bar & chain lubricating system. If the unit continues to seep oil after a few days, the problem may be the vacuum relief valve located in the side of the engine housing between the oil output hole and the bar stud(s).
How do you store a chainsaw so it doesn’t leak oil?
Here are all possible ways to store chainsaw so it doesn’t leak oil;
- Check the Oil Reservoir Before Storage.
- Secure the Plugs Before Storage.
- Check the Saw’s Inner Body Before Storage.
- Hanging Vertical Storage.
- Hanging by Rear Handle.
- Hanging by the Brake stop.
- Don’t Store Chainsaw on Its Sides.
Is it normal for chainsaw to leak bar oil?
In all but very exceptional cases there is nothing wrong with the chainsaw and what appears to be an oil leak is simply oil that has sprayed from the chain as it rotates at high speed, draining from the saw body and guide bar.
Is it normal for a chainsaw to leak bar oil?