How much is a gallon of PhosBan?
Directions: PhosBan can be rinsed briefly before use, but since it is friable, do NOT stir the granules, which would pulverize them. Recommended Usage: 50 g per 50 gal (200 l) saltwater, 50 g per 100 gal freshwater.
Can I use Gfo without a reactor?
Yes, but I wouldn’t recommend it. Carbon and GFO don’t always need to be replaced at the same time. If you run them in separate reactors, you don’t have to remove both medias to replace one. You can, but make sure it doesn’t tumble.
How fast will Gfo reduce phosphates?
BRS High-Capacity GFO: High-density, long-lasting, lower-maintenance phosphate removal. (16 tbsp = 1 cup). After 4-8 weeks the aquarium will have adjusted to the low nutrient level and the amount of GFO can be increased up to 2 tablespoons per 8 gallons of water.
How often should I change RowaPhos?
The reality for someone blindly using RowaPhos is that they start off at 5 ppm and reduce it to 4 ppm by using the wrong sized pack, which they replace after 2 – 3 months by which time the concentration has returned to or exceeded its original level.
Does phosphate cause hair algae?
Hair algae is usually associated with high phosphates, which can often be found in new systems. Phosphates can come from a variety of sources including food, rock and freshwater. All food contains phosphates so over feeding will noticeably increase phosphates over time.
Will a protein skimmer reduce phosphates?
Using a good protein skimmer will strip out organics, before they can release phosphate into the water. An efficient skimmer will remove dissolved and particulate organic matter, improving water quality and limiting phosphates and nitrates.
What is the phosban 150 media reactor?
The PhosBan 150 media reactor has a low profile and built-in hanging bracket making it ideal for “hang on the back” applications. The Phosban reactor works with a variety of filter medias such as activated carbon, GFO, and biopellets.
How much phosban can I put in my Aquarium?
Technical Data Capacity Use with up to a maximum of 200 grams (385 ml) of PhosBan, or a media height of 5 inches (13 cm). Aquarium size One reactor for up to 150 gallons (568 Liters). Multiple reactors may be used for larger aquariums. Recommended flow rate ca. 20 – 30 gal/hr (75 – 115 l/hr).
How do you install a phosban reactor?
2. Locating the reactor The PhosBan reactor can be seated upright in the cabinet, in the filter sump, upright on the floor below the aquarium or hanging on the side or rear of an aquarium. For hanging installations, use threaded bolt provided in the base plate to level it against the aquarium wall.
Can phosban be mixed with activated carbon?
PhosBan may be mixed with phosphate-free activated carbon (HydroCarbon2 from Two Little Fishies). This can provide the necessary media volume when less than 100 grams (190 ml) of PhosBan is used. Do not place ball valve on the exit pipe. Restricting the flow on the exit pipe pressurizes the reactor and can cause leaks.