Why is my Remington Trimmer not working?
If the trimmer intermittently stops working with the power switch still in the ‘on’ position it is possible the device has overheated and the thermal switch has activated and shut off the device to protect it from any damage.
How do I know when my Remington beard trimmer is fully charged?
Switch the power on and the red light will glow to indicate that it is charging. Unit has a 40 minute run-time when fully charged. The batteries cannot be overcharged, but we recommend that charging be discontinued if the trimmer will not be used for a long period of time. The trimmer will be fully charged in 14 hours.
Why is my trimmer not cutting?
If there is rust damage between the teeth, then you will need to replace the blade. The rust dulls your blades and will continue to dull the blades even if they are sharpened. After cleaning your blades, then you MUST align the blades or they will not cut properly no matter how clean and shiny they are.
How many hours should I charge my trimmer?
Charge your trimmer for 8 hours with your USB cable to get 30 minutes of cordless use.
How long does it take a Remington shaver to charge?
Congratulations on your purchase of a premium Remington shaver. Quick Charge shavers recharge in one hour. Five minutes gives you enough power for a single shave.
How do you charge a Remington?
Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. A charging indicator light will come on. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves.
How do you charge a Remington Clipper?
Plug the adaptor into your hair clipper and then plug the charging adaptor unit into a 220-240 volt domestic power outlet. Check to ensure that the hair clipper Off/On/Turbo switch is OFF. The Charging Indicator light will flash whilst charging.
Why won’t my clipper blades cut?
When your blades start to pull the hair the first thing to try is apply two drops of clipper oil to the blades and test cut again. (Oil lubricates the blades and allows them to run at the correct speed and ensure better cutting. It also helps the clipper run cooler.
Why won’t my new clipper blades cut?
Loosen your taper lever. Align your blades to be “almost” parallel to each other; ensuring the stationary blade sits a bit higher than the cutting blade. Set your taper lever to the closed position. Use your left hand to hold the blades together while you tighten them.
Can you overcharge a trimmer?
Your manual may say it is acceptable to leave the cordless clippers in their charging stand all the time, or batteries won’t obtain a memory or become overcharged.