How do you test a starter on a Harley Davidson?

Posted on by David Darling

How do you test a starter on a Harley Davidson?

Run a second ground lead from the battery negative terminal to the solenoid post. Then, run a lead from the starter contact (where the green trigger wire from your start button plugs into) and connect the opposite end to the battery positive post. *The starter shaft should PUSH out.

How do you start a motorcycle with a bad starter?

Make Sure the Kill Switch Is Flipped to the On Position Your kill switch is the button/toggle/lever usually positioned on the right handlebar near the starter button. It will be marked with STOP/RUN or something very similar. Put it in the ‘run’ or ‘on’ position and your bike might just start right up.

How can you tell if a motorcycle starter is bad?

Symptoms of a bad motorcycle starter may include the motorcycle not being able to start at all, the motorcycle only starting intermittently, hearing the starter running even when the engine has already started, and being able to hear a strange clicking sound from the starter.

How do you change a starter on a Sportster?

2 Answers

  1. remove battery.
  2. remove primary cover (leftfoot peg probably needs to come off to do this)
  3. remove rear exhaust pipe.
  4. remove (you might get away with just loosening this) the drivebelt front sprocket cover (right footpeg and front muffler might interfere)
  5. remove starter wiring.
  6. remove starter bolts.
  7. remove starter.

Can you start a bike with a bad starter?

With a little bit of gumption and some boots to the rubber, a motorcycle can start even without a starter! Two main techniques are going to come in handy to be able to go over the starter’s head and get that engine firing, pop starting (also called push-starting or clutch starting) and thump starting.

Can you push start a motorcycle with a bad starter?

Push-starting a motorcycle just eliminates the need to use the starting system. Be sure, then, that your battery or starter is at fault. Pop-startin’ won’t help if you have a bum clutch safety switch, no gas, or a faulty coil.

What are the symptoms of a bad starter relay?

5. Symptoms of starter relay failure

  • The vehicle cannot be started. The failure of a car to start is one of the most obvious signs of a car breakdown.
  • The start relay remains open after the engine is started.
  • The starter makes a clicking sound.
  • The vehicle starts intermittently.