How do I reset my direct box?

Table of Contents

Locate the reset button. On most DIRECTV receivers, there is a small red button located inside the access card door. With others, the button is on the side of the receiver. Press the red button, then wait for your receiver to reboot.

How do I reset my HD receiver?

To reset your receiver:

Unplug the receiver’s power cord from the back of the receiver or from the wall outlet.
Leave unplugged for 30 seconds and plug back in.
The receiver should boot up properly in less than 90 seconds.

Why is my satellite receiver not working?

Try resetting your receiver by pressing and holding the POWER button on your receiver for at least 5 seconds until it resets. If you’re still having issues, please contact us. Try resetting your receiver by pressing and holding the POWER button on your receiver for at least 5 seconds until it resets.

Why my DVR is not working?

Make sure your equipment (TV and cable) is properly connected and powered on. Make sure the coax cable is connected to the outlet. Remove any objects around your receiver to allow proper ventilation. Refresh your receiver.

How do I refresh my receiver on DIRECTV?

To refresh:

Go to myAT account overview and select My DIRECTV.
Choose Manage Package.
Scroll to Manage receivers and elect Refresh receiver.
Your DIRECTV service may be interrupted for a few minutes during the refresh process.

How can I change my DVR password?

Steps to change default password on Hikvision DVR/NVR

Go to Main Menu >> Configuration >> User.
Select the desired user and click ‘Edit’ icon.
Input the old password.
Check change password box.
Input the new password (complex password is highly recommended)
Confirm the new password.

Why does my CCTV say no signal?

A CCTV test monitor is extremely helpful when troubleshooting camera video issues. One of the most common problems when a camera is not displaying video is a bad cable or BNC connection. Using a test monitor, you can temporarily eliminate the power and video cable that your camera is using.

How do I make sure my TV receiver and DVR receiver are connected to the network?

Please go to Menu>Settings>Network Setup> and at the bottom of that screen you should see Wired Connected and Internet Connected. If not, check to make sure your Ethernet cable is securely inserted in the DVR+ (CM-7500) port and in the router/modem at the other end.