How do I setup my Bose PS28?
How to Wire a Bose PS28
- Unplug the PS28 power cord from the wall receptacle.
- Hook up additional Bose speakers to the PS28 using the labeled jacks on the rear of the PS28.
- Connect the PS28 to a Bose Acoustimas or Lifestyle receiver using the supplied audio cable with plug connectors on each end.
- references.
Why did my Bose surround sound stop working?
Check the condition of the speaker wires and be sure they are secure at both ends. Check the speaker wires for any kinks, scratches, cuts or damage. Replace any damaged wires and check that they are securely connected at both ends.
Why is my Bose subwoofer not working?
Try resetting the bass module by disconnecting power for 30 seconds. Disconnect the power cord from the back of the bass module or from the power outlet. Wait 30 seconds, then reconnect power and try again.
How do you clean a Bose subwoofer?
How to Clean Bose Speakers
- Unplug the speakers from the power source. Never use a wet cloth around electronics that are plugged into an outlet.
- Wet a soft cloth so it is lightly damp. Do not use too much water.
- Vacuum the grille panels if dust collects. Be careful when doing this.
What is LFE on Bose subwoofer?
LFE (Low Frequency Effect) – The discrete content sent to the subwoofer from a Dolby or DTS encoded audio track. ( The .1 in a 5.1 or 7.1 audio track) LFE + Main – The low frequencies output to the Subwoofer whether the speaker channels are set to Large or Small.
How do you connect speaker wire to Bose speakers?
Connect the plug of the Bose Lifestyle speaker cable into the Bose speaker adapter’s compatible jack. Peel off 1/2 inch of insulation cover of each two strands from one end of a speaker wire. On the Bose speaker adapter, connect the red speaker wire into the cavity under the red station.
How do I reset my Bose surround sound system?
Reset your product by following these steps:
- Turn the product off.
- Unplug the power cord from the power outlet.
- Disconnect the Interface Module from the Acoustimass Module. Wait 30 seconds.
- Reconnect the Interface Module.
- Reconnect the power cord.
- Retest the system.
How do I reset my Bose subwoofer?
Why did my sub stop working?
If your subwoofer stopped working, there’s a good chance it was blown. To check, unplug the subwoofer and plug it back in. If it still doesn’t work, try switching the input from AUX to SUBWOOFER on the amp. If that doesn’t work, the subwoofer is probably blown and needs to be replaced.
How do I know if my Bose bass module is working?
CONNECT USING THE SOUNDTOUCH 300 REMOTE 2. Press and hold k until the connectivity light l on the soundbar blinks white. Once connected, you hear a tone. The light on the back of the bass module and l on the soundbar glow white.
How do I fix my Bose surround sound?
How to Troubleshoot a Bose Surround System
- Remedy power issues with your Bose system by rechecking the power connections.
- Ensure that you have an input source selected if you have power but get no audio or video output.
- Remedy sound distortion issues by turning down the audio/video source’s volume.