How do you turn off the anti theft system on a Pontiac Grand Prix?
5 Answers. Try to start it, leave the key on for ten minutes, the security light will go off, turn the key off and try to start it again.
How do I deactivate my anti theft system?
There are some cars that will recognize the key from you simply turning it back and forth in the door’s cylinder. It is best to try both methods: holding the key in the door, as well as turning the key both ways to disable the anti-theft system.
How do you fix starting disabled due to theft system?
To disable the system and start your car, use the following steps.
- Step 1: Check the anti-theft light.
- Step 2: Turn on the ignition.
- Step 3: Do a secondary check on the anti-theft light.
- Step 4: Try starting the car fully.
- Step 5: Repeat this process.
How do you override anti-theft system?
Look for a button that allows you to slide the physical key out of the fob. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in this position. This will signal to your car’s system that you have the right key, and will enable you to bypass your car’s alarm system.
What causes a 2002 Pontiac Grand Am Not to start?
On the 2002 Pontiac Grand Am, Olds Alero, and several other GM cars, the Ignition lock cylinder is the most likely cause of cars not starting because of security system malfunctions. Wear in the ignition cylinder causes the electronics within the security module to present a different signal to the yellow wire.
Where is the BCM connector on a 2002 Pontiac Grand Am?
To the right is a diagram and pinout of the center BCM connector. On the 2002 Pontiac Grand Am, the Passlock Data wire (yellow) is on pin B6, and the ground wire (black) is on pin A6. The connector pins are the same on the Oldsmobile Alero. and Chevrolet Impala
Is the 2002 Pontiac Grand Am the same as the Grand Am?
This is not exactly the same as the 2002 Pontiac Grand Am, but it is close enough for my explanation. The three wires connecting the steering assembly at the top of the diagram to the Body Control Module at the bottom of the diagram correspond to the three wires that connect the Grand Am Ignition Module to the Body Control Module.
What wires connect the steering assembly to the ignition module?
The three wires connecting the steering assembly at the top of the diagram to the Body Control Module at the bottom of the diagram correspond to the three wires that connect the Grand Am Ignition Module to the Body Control Module. The Red/White wire (White on the Grand AM) supplies power to the module.