How much is a water pump for a Dodge Durango?
Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor). Of course, shopping around to get a few quotes is your best bet to get the best deal.
How much is a water pump for a 2004 Dodge Durango?
We currently carry 6 Water Pump products to choose from for your 2004 Dodge Durango, and our inventory prices range from as little as $56.99 up to $167.08. On top of low prices, Advance Auto Parts offers 5 different trusted brands of Water Pump products for the 2004 Dodge Durango.
How much does a water pump cost for a 2000 Dodge Durango?
Taking all these points into consideration, you can expect to pay anywhere from $375 to $787 (including parts and labor).
How long does it take to change water pump?
Fixing a broken water pump can take anywhere from two hours to most of a day. A simple replacement should take around two hours, but more complicated work trying to fix a water pump (which will save you money on parts) can take four or more hours.
What is belt tensioner pulley?
A belt tensioner or/and idler pulley is a system that guides the serpentine belt and the timing belt on a car engine. The function of a pulley and a tensioner is to limit the belt slip. The belt tensioner can be mechanic (spring-loaded) or hydraulic.
Do you need to replace thermostat when replacing water pump?
The answer is absolutely because the thermostat itself can be damaged if there is an episode of overheating and, of course, a water pump failure is often associated with overheating.
How much is a water pump on a 2011 Dodge Durango?
How to replace the water pump on a 2002 Dodge Ram?
Dodge Ram 2002-2008: How to Replace Water Pump. Step 1 – Drain the engine coolant. Place your drain pan under the radiator. Take off the radiator cap on the upper passenger’s side corner of the Step 2 – Disconnect the negative battery cable. Step 3 – Remove the coolant recovery tank and washer
How do you tighten the water pump on a hemi?
Start the water pump bolts by hand until all are snug. Tighten the bolts in a criss-cross pattern. The torque spec is 25 ft./lb. for the 4.7 and 3.7 engines. For the Hemi, the torque spec is 30-35 ft./lb. Re-install the coolant hoses onto the pump. You will want to use worm gear clamps instead of the factory spring clamps if they appear weak.
What is the torque on the water pump bolts?
Start the water pump bolts by hand until all are snug. Tighten the bolts in a criss-cross pattern. The torque spec is 25 ft./lb. for the 4.7 and 3.7 engines. For the Hemi, the torque spec is 30-35 ft./lb.