What are the safety operations of a table saw?
Keep the body and face to one side of the saw blade out of the line of a possible kickback. Provide adequate support to the rear and sides of a saw table for wide or long stock. Be careful when waxing, cleaning, or servicing the table. Turn off the power and unplug (or lock out) a saw before doing any work on the saw.
How do I make my table saw safer?
Riving knives are now standard equipment on saws, but older models can be made safer with the addition of a splitter like the MK splitter shown here that attaches to the saw’s throat plate and helps keep material from coming into contact with the back of the blade.
What are some safety tips you would give to a new table saw owner?
Table Saw Safety Tips
- Use Push Sticks and Push Blocks.
- Be Sure to Install the Blade Guard.
- Kickback Pawls are an Essential Table Saw Safety Feature.
- The Riving Knife Helps Prevent Kickback.
- Stand to the Side When Making Rip Cuts.
- Wait Until the Blade Stops Spinning.
- Be Aware of Your Surroundings.
What are 5 safety rules for a table saw?
Safety Rules Safety glasses and hearing protection are required. Never saw freehand. Never clear small pieces while blade is moving. Never adjust saw or setup while saw is running.
Which operation should be performed when using the table saw?
Use the left hand to hold the board against the fence and table. Use the right hand to push the material through the saw. When the stock is less than 6 inches in width, use a pushstick to push the trailing end through the saw. Never allow the hands to come closer than 12 inches to the saw blade.
What equipment is found on a safe table saw?
Safe table saw operation is dependent on a three-part guarding system. A plastic barrier guard is suspended over the blade to prevent inadvertent blade contact from above, the sides and the rear. The standard style guard is supported by a splitter or riving knife.
Is kickback possible with a riving knife?
When you push a workpiece through the saw blade, the riving knife is designed to keep the two cut sections of the board from closing up, thus pinching the saw blade and causing dangerous kickback. Rip cuts are especially prone to kickbacks, and it is here that the riving knife is most important.
Does SawStop really work?
Gass told the commissioners that history has continued to prove his technology effective. To this day the company says SawStop has never been involved in a serious table saw accident and has documented more than 5,000 “finger saves.” He estimates his saws are “99 percent” effective at preventing injuries.
Why do people take the guard off table saw?
3) Also, the blade guard needs to be removed for cutting thin pieces or re-sawing lumber on its edge. It also needs to be removed when making non-through cuts such as dados and grooves. They are sometimes ineffective when making bevel cuts or need to be removed altogether.
Does riving knife prevent kickback?
Rip cuts are especially prone to kickbacks, and it is here that the riving knife is most important. Even though a riving knife is effective in reducing the possibility of a kickback, it cannot prevent it entirely, which is why it is always advisable to follow the basic rules of use for a table saw.